pppos.h

Go to the documentation of this file.

 
/*
 * Redistribution and use in source and binary forms, with or without modification,
 * are permitted provided that the following conditions are met:
 *
 * 1. Redistributions of source code must retain the above copyright notice,
 *    this list of conditions and the following disclaimer.
 * 2. Redistributions in binary form must reproduce the above copyright notice,
 *    this list of conditions and the following disclaimer in the documentation
 *    and/or other materials provided with the distribution.
 * 3. The name of the author may not be used to endorse or promote products
 *    derived from this software without specific prior written permission.
 *
 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR IMPLIED
 * WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
 * MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT
 * SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
 * EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT LIMITED TO, PROCUREMENT
 * OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS
 * INTERRUPTION) HOWEVER CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN
 * CONTRACT, STRICT LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING
 * IN ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY
 * OF SUCH DAMAGE.
 *
 * This file is part of the lwIP TCP/IP stack.
 *
 */
 
#include "netif/ppp/ppp_opts.h"
#if PPP_SUPPORT && PPPOS_SUPPORT /* don't build if not configured for use in lwipopts.h */
 
#ifndef PPPOS_H
#define PPPOS_H
 
#include "net/sys.h"
 
#include "ppp.h"
#include "vj.h"
 
/* PPP packet parser states.  Current state indicates operation yet to be
 * completed. */
enum {
  PDIDLE = 0,  /* Idle state - waiting. */
  PDSTART,     /* Process start flag. */
  PDADDRESS,   /* Process address field. */
  PDCONTROL,   /* Process control field. */
  PDPROTOCOL1, /* Process protocol field 1. */
  PDPROTOCOL2, /* Process protocol field 2. */
  PDDATA       /* Process data byte. */
};
 
/* PPPoS serial output callback function prototype */
typedef u32_t (*pppos_output_cb_fn)(ppp_pcb *pcb, u8_t *data, u32_t len, void *ctx);
 
/*
 * Extended asyncmap - allows any character to be escaped.
 */
typedef u8_t ext_accm[32];
 
/*
 * PPPoS interface control block.
 */
typedef struct pppos_pcb_s pppos_pcb;
struct pppos_pcb_s {
  /* -- below are data that will NOT be cleared between two sessions */
  ppp_pcb *ppp;                    /* PPP PCB */
  pppos_output_cb_fn output_cb;    /* PPP serial output callback */
 
  /* -- below are data that will be cleared between two sessions
   *
   * last_xmit must be the first member of cleared members, because it is
   * used to know which part must not be cleared.
   */
  u32_t last_xmit;                 /* Time of last transmission. */
  ext_accm out_accm;               /* Async-Ctl-Char-Map for output. */
 
  /* flags */
  unsigned int open            :1; /* Set if PPPoS is open */
  unsigned int pcomp           :1; /* Does peer accept protocol compression? */
  unsigned int accomp          :1; /* Does peer accept addr/ctl compression? */
 
  /* PPPoS rx */
  ext_accm in_accm;                /* Async-Ctl-Char-Map for input. */
  struct pbuf *in_head, *in_tail;  /* The input packet. */
  u16_t in_protocol;               /* The input protocol code. */
  u16_t in_fcs;                    /* Input Frame Check Sequence value. */
  u8_t in_state;                   /* The input process state. */
  u8_t in_escaped;                 /* Escape next character. */
};
 
/* Create a new PPPoS session. */
ppp_pcb *pppos_create(struct netif *pppif, pppos_output_cb_fn output_cb,
       ppp_link_status_cb_fn link_status_cb, void *ctx_cb);
 
#if !NO_SYS && !PPP_INPROC_IRQ_SAFE
/* Pass received raw characters to PPPoS to be decoded through lwIP TCPIP thread. */
err_t pppos_input_tcpip(ppp_pcb *ppp, u8_t *s, int l);
#endif /* !NO_SYS && !PPP_INPROC_IRQ_SAFE */
 
/* PPP over Serial: this is the input function to be called for received data. */
void pppos_input(ppp_pcb *ppp, u8_t* data, int len);
 
 
/*
 * Functions called from lwIP
 * DO NOT CALL FROM lwIP USER APPLICATION.
 */
#if !NO_SYS && !PPP_INPROC_IRQ_SAFE
err_t pppos_input_sys(struct pbuf *p, struct netif *inp);
#endif /* !NO_SYS && !PPP_INPROC_IRQ_SAFE */
 
#endif /* PPPOS_H */
#endif /* PPP_SUPPORT && PPPOL2TP_SUPPORT */